For qsat so far only three models Namely Q23G, Q26G and Q28G, these are the official supported decoders... download these patch and load to the specified decoder and you are sure your decoder now has a fully supported autoroll function for powervu.
DOWNLOAD:FOR Q28G COMBO
But for other Qsat models that are not listed here, there is a solution for you.....the question is how can we load this patch considering the fact that it is not any of q23g, q26g, or q28g...
here is what we do... Firstly you need to .locate a very good technicians around you.. if you are using any of the old models of qsat, all you need do is to find the IC for either q23g or q26g and exchange it with yours.
For instance if you have q13g, you can get an Ic for q26G or Q23G and change it with the IC of your Q13G... After Successful change ....you should now load the patch of the Ic model you exchanged either Q23g if you used q23G Ic or Q26g if you made use of q26G ic... and your decoder will be up and running as auto-roll just like the original series of q23, 26 and 28G respectively.
Note: you need to be very careful while doing this so i recommend you locate a good technician that knows about it....i will try to give a comprehensive note on how to do it...
No need changing the Ic's you can download for other autoroll supported models below
DOWNLOAD: FOR Q13G
DOWNLOAD: FOR Q11G
ALL Decoders lst and provided above are fully auto roll